Bnc 1105 Universal Counter Bedienungsanleitung PDF herunterladen (Seite 34)

3434

Vmax (positive peak), Vmin (negative peak), Vc (average from

positive and negative peak) or Vpp (peak-to-peak).

c. Use the selections in the CH1 or CH2 to set the input conditions and

the trig Sens.

d. Use Show Status button to check the conditions of Input, Volt, Stats

and Limit.

e. Use Save&Recall button to save your settings (i.e., changes made in

steps a-d) if it’s needed (refer to Ch.4.9).

5. Press RUN button to make continuous measurements.

6. Press STOP/SINGLE button to stop current measurement or to make

single measurement.

Remote Interface Command

Use the following commands for making voltage peak measurement:

[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLtage:MAXimum [1|2]”

[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLtage:MINimum [1|2]”

[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLtage: PTPeak [1|2]”

[:SENSe]:FUNCtion[:ON] “[:][XNONe:]VOLtage: CENter [1|2]”

:CONFigure[:SCALar][:VOLTage]: MAXimum [(@1)|(@2)]

:CONFigure[:SCALar][:VOLTage]: MINimum [(@1)|(@2)]

:CONFigure[:SCALar][:VOLTage]:PTPeak [(@1)|(@2)]

:CONFigure[:SCALar][:VOLTage]: CENter [(@1)|(@2)]

:READ[[:SCALar][:VOLTage]:PTPeak]?

:MEASure[:SCALar][:VOLTage]:MAXimum? [(@1)|(@2)]

:MEASure[:SCALar][:VOLTage]:MINimum? [(@1)|(@2)]

:MEASure[:SCALar][:VOLTage]:PTPeak? [(@1)|(@2)]

:MEASure[:SCALar][:VOLTage]:CENter? [(@1)|(@2)]

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 196 197

Keine Kommentare

Bnc 1105 Universal Counter Bedienungsanleitung Seite 34