Bnc 835-3 Programmer Manual Bedienungsanleitung PDF herunterladen (Seite 27)

Berkeley Nucleonics

www.Berkeley Nucleonics.com

835-3

Programmer’s Manual v1.0

Page 27 of 37

:STARt

[SOURce]:POWer:STARt <value><unit>

[SOURce]:POWer:STARt?

This command sets the first amplitude point in a step sweep.

*RST ?

Range Refer to [:LEVel][:IMMediate][:AMPLitude] command for the output power

ranges.

:STOP

[SOURce]:POWer:STOP <value><unit>

[SOURce]:POWer:STOP?

This command sets the last amplitude point in a step sweep.

*RST ?

Range Refer to [:LEVel][:IMMediate][:AMPLitude] command for the output power

ranges.

[SOURce]:AM Subsystem (Amplitude Modulation)

Command Parameters Unit (default)

[SOURce]:AM:DEPTh <value>

0.8 (80 PCT)

[SOURce]:AM:STATe ON|OFF|1|0

[SOURce]:AM:INTernal:FREQuency <value> 400 Hz

:AM:INT:FREQuency

[SOURce]:AM:INTernal:FREQuency <value><unit>|UP|DOWN

[SOURce]:AM:INTernal:FREQuency?

This command sets the internal amplitude modulation rate.

*RST 400 Hz

Range 400 Hz and 1000 Hz

The RF carrier is modulated when you have set the signal generator’s AM modulation

state to ON.

Whenever amplitude modulation is enabled, the AM on is in the display.

:AM:DEPTh

[SOURce]:AM[:DEPTh]: <value>

[SOURce]:AM[:DEPTh]:?

This command sets the amplitude modulation depth 0...1.

*RST 0.8

Range 0-0.99

[SOURce]:FM Subsystem (Frequency Modulation)

Command Parameters Unit (default)

[SOURce:]FM:DEViation <value>

10000 Hz

[SOURce:]FM:SENSitivity <value>

10000 Hz/V

[SOURce:]FM:SOURce EXTernal|LFGenerator

EXT

[SOURce:]FM:STATe ON|OFF|1|0

OFF

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 36 37

Kommentare zu diesen Handbüchern

Keine Kommentare

Bnc 835-3 Programmer Manual Bedienungsanleitung Seite 27

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Generatoren Bnc 835-3 Programmer Manual